In case you have library clients, an "audit libr" should be run on those
as well.

Regards,
Shawn
________________________________________________
Shawn Drew





Internet
Larry.Peifer AT SCE DOT COM

Sent by: ADSM-L AT VM.MARIST DOT EDU
01/29/2009 08:07 PM
Please respond to
ADSM-L AT VM.MARIST DOT EDU


To
ADSM-L
cc

Subject
[ADSM-L] What did I miss





Just went through a tape library swap out but ran into a problem with
getting the tsm server to see the tape library volumes.    Deleted and
added back the library, drives and paths in TSM.  The new library is a
duplicate match of the old one.  So we took all of the tapes from old and
put them into new.   The tms data base and all other components remained
the same.  What method should be used to have tsm read in the library
volumes so it knows what tapes are scratch or have data or are the
dbbackup?  I tried 'audit library' and 'checkin libvol' for both scratch
and private but 'q libvol' never showed 'Last Use' as Data, or Dbbackup.

Also,  what is the command for keeping the dsmserv from starting up and
immediately starting it's admin jobs?

Thanks in advance.


This message and any attachments (the "message") is intended solely for
the addressees and is confidential. If you receive this message in error,
please delete it and immediately notify the sender. Any use not in accord
with its purpose, any dissemination or disclosure, either whole or partial,
is prohibited except formal approval. The internet can not guarantee the
integrity of this message. BNP PARIBAS (and its subsidiaries) shall (will)
not therefore be liable for the message if modified. Please note that certain
functions and services for BNP Paribas may be performed by BNP Paribas RCC, Inc.