Re: [ADSM-L] Labelling mass volume of tapes with Label Libvol
2008-11-13 10:50:21
You could have used the search=yes and the volrange to fire up multiple
label libvol commands... fire off 25 commands each doing a range of 100
tapes.
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Andrew Collyer
Sent: Thursday, November 13, 2008 9:36 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] Labelling mass volume of tapes with Label Libvol
Hi,
I have a new TS3500 library with 2500 scratch tapes. I'm running a LABEL
LIBVOL command within TSM 5.5.1.1 but unfortunately it is labelling one
tape at a time. I'm using the barcode as the source.
Is there a way to label more than one tape at a time? It's a good waste of
time and plenty of drives!
Thanks.
Andrew
-----------------------------------------
Find out about our efforts to create gardens in Yorkshire's primary
schools using a million green fingers by following this link:
http://greenfingers.yorkshirewater.com/
The information in this e-mail is confidential and may also be
legally privileged. The contents are intended for recipient only
and are subject to the legal notice available at
http://www.keldagroup.com/email.htm Yorkshire Water Services
Limited
Registered Office Western House Halifax Road Bradford BD6 2SZ
Registered in England and Wales No 2366682
|
|
|