[ADSM-L] Define Clientaction
2008-10-15 13:12:13
The DEFINE CLIENTACTION command runs as DEFINE CLIENTACTION * domain=*
action=incremental as default parameters.
We had an instance where all the clients started their incrementals when
a DEFINE CLIENTACTION (with no parameters) was run accidentally...
Is this command syntax reasonable?
Regards, Rama
--------------------------------------------------------
This message w/attachments (message) may be privileged, confidential or
proprietary, and if you are not an intended recipient, please notify the
sender, do not use or share it and delete it. Unless specifically indicated,
this message is not an offer to sell or a solicitation of any investment
products or other financial product or service, an official confirmation of any
transaction, or an official statement of Merrill Lynch. Subject to applicable
law, Merrill Lynch may monitor, review and retain e-communications (EC)
traveling through its networks/systems. The laws of the country of each
sender/recipient may impact the handling of EC, and EC may be archived,
supervised and produced in countries other than the country in which you are
located. This message cannot be guaranteed to be secure or error-free. This
message is subject to terms available at the following link:
http://www.ml.com/e-communications_terms/. By messaging with Merrill Lynch you
consent to the foregoing.
--------------------------------------------------------
|
|
|