[ADSM-L] Restart Backupset
2008-02-25 06:41:23
Hi *SM-ers
I hope the weekend was great and that your TSM-servers went much better than
ours.
We have run a "Generate Backupset" job on our TSM Server and normally does this
job takes around 1-2 weeks to run.
But guess what. Almost in the end of our "Generate backupset" did our TSM
Server get a Media Error and then automatic just killed the process.
I tried to look around in TSM to see if I can run some sort of restart command.
But it looks like I need to restart the entire process and start all over again.
This is not good for us because of it takes almost 2 weeks and we don't really
have time to restart it until we going to start our next "Generate Backupset"
process.
My question to you all is:
Is there any way for me to restart the process where if left of or can I set
some settings in TSM so if it goes media error that it just tell us the error
and then continue on another tape?
I got a feeling that "Generate Backupset" is not that robust so we really can
trust it.
Please come with advice or any feedback.
TSM Runs on: Windows Server 2003 (x86 x 4 CPU)
TSM Server version: 5.4.1.2
Best Regards / Med Vänlig Hälsning
Christian Svensson
Products Specialist
Cristie Nordic AB
Visit: Kista Entré, Knarrarnäsgatan 7, Kista
Support WW: +44-145-384-7009
Support US/CAN: +1-866-832-2267
Cell: +46-70-325-1577
E-Mail: Christian.Svensson AT cristie DOT se <mailto:Christian.Svensson AT
cristie DOT se>
Visit Us@ http://www.cristie.com
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [ADSM-L] Restart Backupset,
Christian Svensson <=
|
|
|