Yes, I tried both serial and element=autodetect
"ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> writes:
>It sounds like the serial information to me. Did you try the
>serial=autodetect when defining it? I had to do this the last time I added
>some LTO3 drives.
>
>On 6/12/07, Chris McKay <Chris.McKay AT ycdsb DOT ca> wrote:
>>
>> We did recently update the firmware on both the library, and the drives,
>> also updated the changer and tape device drivers on the server as well.
>>
>>
>>
>> "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> writes:
>> >Hi,
>> >
>> >By any change has there been a hardware change?
>> >
>> >- delete drive from ITSM config,
>> >- reboot Windows
>> >- define drive serial=autodetect
>> >- define path to drive
>> >
>> >
>> >Regards,
>> >
>> >Karel
>> >
>> >-----Original Message-----
>> >From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf
>Of
>> >Chris McKay
>> >Sent: dinsdag 12 juni 2007 14:25
>> >To: ADSM-L AT VM.MARIST DOT EDU
>> >Subject: Define path problems
>> >
>> >Hi All,
>> >
>> >I am having problems with replacing a SCSI LTO tape drive in my 3584
>> >library. Usually a routine procedure, but this time I am having major
>> >difficulties. Whenever I try to redefine the path for this particular
>> >drive I get the following error: ANR8972E DEFINE PATH: Unable to find
>> >the element number for drive DRIVE3 in library 3584LIB
>> >
>> >I have been talking with both TSM software support, and hardware
>> >support, and still not much luck. The drive is being detected by the
>> >server properly, and the library detects the drive fine as well. We
>have
>> >tried two different drives as well. I did notice the library specialist
>> >does report a different serial number than the library itself reports
>> >though..
>> >The server is Windows 2000. Has anyone seen this before? Any ideas???
>> >
>> >Take Care,
>> >
>> >Chris
>> >
>> >Chris McKay
>> >Systems Administrator
>> >York Catholic District School Board
>> >
>> >
>> >
>> >
>> >______________________________________________
>> >This message is for the sole use of the intended recipients and may
>> >contain confidential and privileged information. Any unauthorized
>> >review, use, disclosure or distribution is prohibited. If you are not
>an
>> >intended recipient, please contact the sender by reply email and
>destroy
>> >all copies of the original message. Thank you for your cooperation.
>>
>>
>>
>>
>> ______________________________________________
>> This message is for the sole use of the intended recipients and may
>> contain confidential and privileged information. Any unauthorized
>review,
>> use, disclosure or distribution is prohibited. If you are not an
>intended
>> recipient, please contact the sender by reply email and destroy all
>copies
>> of the original message. Thank you for your cooperation.
>>
______________________________________________
This message is for the sole use of the intended recipients and may contain
confidential and privileged information. Any unauthorized review, use,
disclosure or distribution is prohibited. If you are not an intended recipient,
please contact the sender by reply email and destroy all copies of the original
message. Thank you for your cooperation.
|
