Hi all,
I need to know how to verify the backup content. Currently, I'm using the 'q
content' command.
What I want to do here is I need to verify it by reading the backup tape to
know the backup content rather than using
The query command. It's the user requirement to make sure the existing of
data.
Thanks
NORITA BINTI HASAN
Senior Programmer
Enterprise Systems Services
Information Communications Tech. Div
6th Floor,Pos Malaysia HQ
50670 Kuala Lumpur
* : 03 - 22756638
*: 016 - 6090530
Pos Malaysia Berhad is Malaysia's national postal company
Visit us online at www.pos.com.my
NOTICE
This message may contain privileged and/or confidential
information. If you are not the addressee or authorised
to receive this email, you must not use, copy, disclose
or take any action based on this email. If you have
received this email in error, please advise the sender
immediately by reply e-mail and delete this message.
Pos Malaysia Berhad takes no responsibility for the
contents of this email.
Email scanned and protected by POS Malaysia
|