Re: AW: Scratch Tapes
2005-08-05 09:25:23
The scratch tapes appear to be fine and
---------------------------------------
Delay Period for Volume Reuse 0
---------------------------------------
How can I tell how many times a tape can be used and how many times an
individual tape was used?
If it's low(did not setup server) how can I change it to a higher number?
Thanks
Eric
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Schaub Joachim Paul ABX-SECE-ZH
Sent: Friday, August 05, 2005 8:20 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] AW: Scratch Tapes
Reusedelay settings?
The scratch volumes have access READW?
Regards
joachim
-----Ursprüngliche Nachricht-----
Von: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] Im Auftrag
von Jones, Eric J
Gesendet: Freitag, 5. August 2005 13:34
An: ADSM-L AT VM.MARIST DOT EDU
Betreff: Scratch Tapes
Good morning.
I have a question on scratch tapes and how/when they are used.
We are using TSM 5.2.2 with AIX 5.2.
We have around 225 LTO2 tapes in the library of which about 60 are used.
The are numbered from TS2000 - TS2225.
For some time the lower numbered tapes were regularly reused as they became
available(scratch from off-site) or reclamation of on-site tapes.
Lately TSM seems to be picking the tapes that have never been used and the
lower number tapes don't seem to be selected.
How does TSM determine what scratch tape to use?
I just want to make sure it is not stopping using certain tapes in the library.
They appear fine and are listed as "SCRATCH" in the library.
Just noticed and figured I would ask before I ran into any problems.
Eric Jones
PLATFORM AND SERVER SOLUTIONS
Owego, NY
Phone: 607-751-4133
|
|
|