As far as I know, there are two ways to do a command-line backup in netware...

1.  Type "dsmc" at the server command line.  At the dsmc prompt that comes up, 
type "i" , or something like "backup vol1:\dir1\*"
2.  At the novell command prompt type "dsmc backup vol1:\dir1\*"

The 1st way will keep you in the backup client window until you exit out.  The 
2nd way should automatically exit out once the backup is complete.


Troy Frank
Network Services
University of Wisconsin Medical Foundation
608.829.5384

>>> dbrowne AT HUMANA DOT COM 6/21/2005 5:59:56 AM >>>
I

Is there a command to automatically exit upon completion of the command
line backup, and not leave the window sitting at "Press any key to
continue"?



The information transmitted is intended only for the person or entity to which 
it is addressed and may contain CONFIDENTIAL material.  If you receive this 
material/information in error, please contact the sender and delete or destroy 
the material/information.

Confidentiality Notice follows:

The information in this message (and the documents attached to it, if any)
is confidential and may be legally privileged. It is intended solely for
the addressee. Access to this message by anyone else is unauthorized. If
you are not the intended recipient, any disclosure, copying, distribution
or any action taken, or omitted to be taken in reliance on it is
prohibited and may be unlawful. If you have received this message in
error, please delete all electronic copies of this message (and the
documents attached to it, if any), destroy any hard copies you may have
created and notify me immediately by replying to this email. Thank you.