Re: question about ANR8341I

2004-04-23 07:53:45
Subject: Re: question about ANR8341I
From: Richard Sims <rbs AT BU DOT EDU>
Date: Fri, 23 Apr 2004 07:53:14 -0400
>hi all when I do backup operation anything is OK but everytime I try to
>archive something I get the same error
>04/19/04   17:34:16   ANR8341I End-of-volume reached for LTO volume 716ADM.
>04/22/04   18:30:21   ANR8341I End-of-volume reached for LTO volume 715ADM
>q vol output as follow=20
>715ADM     JW_ARCHIVE   3583CLS    190,734.0  46.5     Filling
>716adm is about 50%

This may depend upon what you are archiving... A very large file will likely
span volumes, and TSM has traditionally not updated volume statistics until
the aggregate or large file has been completely written (to its final
volume).  So if you perform the query as the operation is still writing
the file, that spanned-from volume will still show Filling rather than Full.

If the query was done after the Archive had completed:
I seem to recall that there were tape drive microcode issues which could
contribute to this kind of effect.

   Richard Sims

<Prev in Thread] Current Thread [Next in Thread>