tsm fc devices and aix 5.2 multipath i/o?
I'm currently configuring our new TSM server. This new box has 4 FC
adapters that all connect to the same FC switch that again connects to
our STK 9840C and STK 9940B drives. I was under the impression that with
AIX 5.2 I would be able to configure AIX to know about the redundancy in
this set-up and do some automatic fail-over and load-balancing.
Unfortunately, this does not seem to be the case, the devices are not
multi-path capable according to AIX. Has anobody succesfully configured
TSM on AIX using multipath I/O ? isit possible? If so, what drivers did
you load in AIX to enable this?
Met vriendelijke groeten,
SARA - Reken- en Netwerkdiensten http://www.sara.nl
High Performance Computing Tel. +31 20 592 3000 Fax. +31 20 668 3167
"I really didn't foresee the Internet. But then, neither did the
computer industry. Not that that tells us very much of course - the
computer industry didn't even foresee that the century was going to
end." -- Douglas Adams
|<Prev in Thread]
||[Next in Thread>|
- tsm fc devices and aix 5.2 multipath i/o?,
Remco Post <=