Yes, I know which element I need to use.. But I need to know how to set a
specific device such as rmt0 to a specific ww_name on one of my four FC 3580
drives.

> From: Clarence Beukes <clarence AT ZA.IBM DOT COM>
> Reply-To: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
> Date: Mon, 30 Jun 2003 09:01:57 +0200
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: WW_Name fiasco
>
> If  your TSM Server is on AIX:
>
> lsattr -El rmtx
>
> Check for ww_name (last three digits) will teel you which element you
> should use.
>
> Clarence Beukes
> Advisory IT Specialist - Tivoli Certified Consultant
> Geomar SSO Mid Range and Application Support Discipline
> Location:  IBM Park Sandton, IA2G
> Tel: +27 (0) 11 302-6622   Cell: +27 (0) 82 573 5665
> E-mail: clarence AT za.ibm DOT com
>
>
>
>
>                     Shawn Price
>                     <sprice@MORRISONH        To:       ADSM-L AT VM.MARIST 
> DOT EDU
>                     OMES.COM>                cc:
>                     Sent by: "ADSM:          Subject:  WW_Name fiasco
>                     Dist Stor
>                     Manager"
>                     <[email protected]
>                     .EDU>
>
>
>                     30/06/03 07:38 AM
>                     Please respond to
>                     "ADSM: Dist Stor
>                     Manager"
>
>
>
>
>
> All,
> I recently had to remove and redefine all of my Fiber Channel paths to my
> ESS shark and to my 3584 library. Now my ww_names do not match up to the
> device names (eg. /dev/rmt0 was xxxxx2601, now it's xxxxxx2603). Does
> anyone
> know how to specify which ww_name points to a particular device name?
>
> Thanks in advance.
>
> Shawn
>