Re: Tape reclaim & stgpool migration question/
2003-06-19 11:52:45
You may have a little confusion about Reclamation and Migration.
Do 'q stg xxxpool f=d' and find 'Reclamation Threshold' which governs how
reclamation will be done.
Highmig=xx and lowmig=xx are parameters that works only for Migration of data
from one pool to another. When a stg reaches highmig #, it kicks migration
until reaches lowmig#.
Hope this helps.
Gus
>>> bp3965 AT SBC DOT COM 06/19/03 11:25AM >>>
All-
I recently created reclaim stgpool with upper mig to 80% and lower mig to
0%.
But the CFILE devclass stgpool that is disk when gets to 80 % migrate level
, tapes do not stop to reclaim but it continues .What might have been
missing????
Thanks in advance
Balanand Pinni
|
|
|