Hi *SM-ers!
In the IBM Redbook "IBM Magstar Tape Products Family: A Practical Guide" I
read the following line:
For 3590 Magstar drives, use a value of 999 mounts to perform cleaning based
on drive request rather than library initiated.
So I changed the value to 999, but nothing happens. Both drives are still
displaying *CLEAN. The library doesn't seem to pick up the drives cleaning
request. How can I make the library clean the drives?
Thanks in advance for any reply!!!
Kindest regards,
Eric van Loon
KLM Royal Dutch Airlines
**********************************************************************
For information, services and offers, please visit our web site:
http://www.klm.com. This e-mail and any attachment may contain confidential and
privileged material intended for the addressee only. If you are not the
addressee, you are notified that no part of the e-mail or any attachment may be
disclosed, copied or distributed, and that any other action related to this
e-mail or attachment is strictly prohibited, and may be unlawful. If you have
received this e-mail by error, please notify the sender immediately by return
e-mail, and delete this message. Koninklijke Luchtvaart Maatschappij NV (KLM),
its subsidiaries and/or its employees shall not be liable for the incorrect or
incomplete transmission of this e-mail or any attachments, nor responsible for
any delay in receipt.
**********************************************************************
|