I found the dsmerror.log to be a lot more helpful!
Are you using CAD mode (client acceptor starts the scheduler and/or
webclient)?
Also is this cluster running either TDP SQL or Exchange?  If so check the
port numbers!
I set my SQL cluster this way:
Baclient for local disk on 1581
TDP SQL on 1582
Cluster resources on 1583.

--------------------------------------
Bruce Kamp
Midrange Systems Analyst II
Memorial Healthcare System
E: bkamp AT mhs DOT net
P: (954) 987-2020 x4597
F: (954) 985-1404
---------------------------------------


-----Original Message-----
From: prasanna S ghanekar [mailto:gpresy AT lycos DOT com]
Sent: Monday, February 03, 2003 10:39 AM
To: Kamp, Bruce
Subject: RE: WEB Client install fails on NT cluster server


It is for a cluster resource and I have specified a different HTTPPORT in
the options files, which it picks up at the time of installation. For some
reason, I did not look much in the nt event logs.

Thanks
--

On Mon, 3 Feb 2003 07:11:49
 Kamp, Bruce wrote:
>Where there any errors in the dsmerror.log?
>Is this for a cluster resource?  If so did you specify a different
>httport?
>
>
>--------------------------------------
>Bruce Kamp
>Midrange Systems Analyst II
>Memorial Healthcare System
>E: bkamp AT mhs DOT net
>P: (954) 987-2020 x4597
>F: (954) 985-1404
>---------------------------------------
>
>
>-----Original Message-----
>From: prasanna S ghanekar [mailto:gpresy AT LYCOS DOT COM]
>Sent: Sunday, February 02, 2003 11:29 PM
>To: ADSM-L AT VM.MARIST DOT EDU
>Subject: WEB Client install fails on NT cluster server
>
>
>Folks,
>
>Based on the Expert advice, I followed all instructions to configure
>and setup TSM Backup client for NT cluster server.Then, I moved on to
>setup Web client in Cluster environment. As the manual says, I used
>"DSMCUTIL" to install services and not the setup wizard. Also, I was
>cautious in looking at the Group and Node ownership on the cluster
>while installing these services.
>
>Here is what happens,
>
>DSMCUTIL installed services on both nodes but when you try to start
>those, I get "incorrect parameter" and the services do not start.
>
>Is there any workaround ? I did test the backups for physical nodes and
>cluster node using scheduler service and it went fine.
>
>Any help is greatly appreciated..
>
>Thanks,
>
>Prasanna Ghanekar
>EDS GMTG MI
>
>
>_____________________________________________________________
>Get 25MB, POP3, Spam Filtering with LYCOS MAIL PLUS for $19.95/year.
>http://login.mail.lycos.com/brandPage.shtml?pageId=plus&ref=lmtplus
>


_____________________________________________________________
Get 25MB, POP3, Spam Filtering with LYCOS MAIL PLUS for $19.95/year.
http://login.mail.lycos.com/brandPage.shtml?pageId=plus&ref=lmtplus