What do you mean TSM only sees one - the TSM driver creates only one
mtX.X.X.X device, you have only one in "Query DRives" or have defined only
one path (server -> drive)?
Manual drives are just like other ones. If you assume something like "def
path manuallib srctype=server desttype=library
dev=LBserver_room.human_operator" the rest is just the same. If drives are
of same technology you can group them in "multi-head" library. If are
different each drive type must form separate library.
In your case:
- if the problem is with the driver, handle it as usual - check first
isn't Windows grabbing the drives before TSM driver.
- if configuration problem, check that you have 1 library in "q libr
<manual_lib>", 4 drives in "q dr <manual_lib>" and 4 paths (1 for each
drive) in "q path".

Zlatko Krastev
IT Consultant






"Adams, Matt (US - Hermitage)" <maadams AT DELOITTE DOT COM>
Sent by: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
21.11.2002 23:06
Please respond to "ADSM: Dist Stor Manager"


        To:     ADSM-L AT VM.MARIST DOT EDU
        cc:
        Subject:        TSM Server setup


Hi all,

I have a test TSM server running 5.1.5.2 on W2K.  There is a QUANTUM DLT
7000 SCSI attached 4 drive manual library.  I am using the TSM device
driver
to see the tape drive.  I can label and use a tape in one of the drives.

The problem is there is 4 tape drives, but TSM only sees one.  Is there a
driver or configuration issue??  My experience in manual drives is very
limited so any suggestions are greatly appreciated.

Regards,

Matt
- This message (including any attachments) contains confidential
information
intended for a specific individual and purpose, and is protected by law. -
If you are not the intended recipient, you should delete this message and
are hereby notified that any disclosure, copying, or distribution of this
message, or the taking of any action based on it, is strictly prohibited.