To my knowledge, if you are on maintenance, the CE will apply the code to
the drives. However, it is a lot easier if you just get the code and use
tapeutil to load it from your host, no tape required.
Paul D. Seay, Jr.
Technical Specialist
Naptheon Inc.
757-688-8180
-----Original Message-----
From: Lloyd Dieter [mailto:dieter AT SNRGY DOT COM]
Sent: Sunday, October 20, 2002 9:31 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: 3590 Firmware
All,
We recently replaced a set of 3590B drives with H's in a 3494. During the
upgrade, I inquired of the CEs regarding what the latest firmware was, and
if they could verify that the upgraded drives had the latest code.
The reply I received was that the procedures for 3590 firmware updates had
changed, and that the customer is now responsible for obtaining the FMR
tape.
Anytime in the past I have gone through firmware updates on 3590 drives, the
CE always provided/created the FMR tape.
A quick check around the web site doesn't seem to indicate anything new
along these lines, nor does a visit to index.storsys.
When I asked one of the CEs for the procedure for getting the code, he
provided me with an e-mail address of someone within IBM. I fired one off
to him, along with the information I was told I required (Co. name, drive
SN, etc.), but have received no reply.
Has anyone else heard this, or are these guys a little off base?
-Lloyd
--
-----------------------------------------------------------------
Lloyd Dieter - Senior Technology Consultant
Synergy, Inc. http://www.synergyinc.cc ldieter AT snrgy DOT com
Main:585-389-1260 fax:585-389-1267
-----------------------------------------------------------------
|