Try just unplugging the Ethernet cable at the rear of 3584 for a
few seconds and then plugging back in - I'm serious.  There is
some problem with the Ethernet I/F that IBM Tucson is working on.
It's particularly a problem using 100MB.

David Longo

>>> Becky.Davidson AT SLBG DOT COM 08/21/02 10:39AM >>>
Has anyone else experienced the need to on an almost weekly basis reboot
their IBM 3584 so that you can get access to the LTO Specialist again?

Everything else seems to work fine I just can't get into the gui.  I am
running at library code level 2460.

Any thoughts or wisdom would be greatly appreciated.

Becky Davidson
Data Manager
EDS/Sara Lee Bakery Group
voice: 314-259-7589
fax: 314-877-8589
email: becky.davidson AT slbg DOT com 



"MMS <health-first.org>" made the following
 annotations on 08/21/2002 01:28:37 PM
------------------------------------------------------------------------------
This message is for the named person's use only.  It may contain confidential, 
proprietary, or legally privileged information.  No confidentiality or 
privilege is waived or lost by any mistransmission.  If you receive this 
message in error, please immediately delete it and all copies of it from your 
system, destroy any hard copies of it, and notify the sender.  You must not, 
directly or indirectly, use, disclose, distribute, print, or copy any part of 
this message if you are not the intended recipient.  Health First reserves the 
right to monitor all e-mail communications through its networks.  Any views or 
opinions expressed in this message are solely those of the individual sender, 
except (1) where the message states such views or opinions are on behalf of a 
particular entity;  and (2) the sender is authorized by the entity to give such 
views or opinions.

==============================================================================