Probably the default is NO to make the current behaviour of MOVE DATA
consistent with older versions, where the reconstruct option did not
exists and where MOVE DATA did not reconstruct aggregates. Today, I
allways use RECONST=YES.

Gerhard Wolkerstorfer <Gerhard.Wolkerstorfer AT T-SYSTEMS DOT AT> schrieb:
> I hardly can see any differences in the performance.........

> Karel.Bos AT NUON DOT COM (Karel Bos) am 29.07.2002 12:08:26

> Bitte antworten an ADSM-L AT VM.MARIST DOT EDU

> An:   ADSM-L AT VM.MARIST DOT EDU
> Kopie:     (Blindkopie: Gerhard Wolkerstorfer/DEBIS/EDVG/AT)

> Thema:    Re: MOVE DATA - Reconstruct Yes/No



> Performance??

> -----Oorspronkelijk bericht-----
> Van: Gerhard Wolkerstorfer [mailto:Gerhard.Wolkerstorfer AT T-SYSTEMS DOT AT]
> Verzonden: maandag 29 juli 2002 7:38
> Aan: ADSM-L AT VM.MARIST DOT EDU
> Onderwerp: MOVE DATA - Reconstruct Yes/No


> Hi all,
> is there any reason, why a MOVE DATA command with Reconstruct=No should be
> used
> ?
> The default is NO.
> I always use YES....and cannot see any bad things......

> Regards
> Gerhard Wolkerstorfer

--
Reinhard Mersch                        Westfaelische Wilhelms-Universitaet
Reinhard Mersch                        Westfaelische Wilhelms-Universitaet
Zentrum fuer Informationsverarbeitung - ehemals Universitaetsrechenzentrum
Roentgenstrasse 9-13, D-48149 Muenster, Germany      Tel: +49(251)83-31583
E-Mail: mersch AT uni-muenster DOT de                       Fax: 
+49(251)83-31653