You didn't mention what library you have, but here is what I see.
In your command replace "tapename" with labelsource=barcode.
Ypu are most likely failing because you say search=bulk and also
specify a tapename.

David Longo

>>> Jeff.Theisen AT US.BOSCH DOT COM 04/10/02 07:57PM >>>
I would like to import more then one piece of media at a time to turn it
into scratch media
but keep receiving error messages. So far only one tape can be imported at a
time for this
procedure. I have tried the command:

label libv libname search=bulk tapename  checkin=scr overwrite=yes

Any ideas would be greatly appreciated.



"MMS <health-first.org>" made the following
 annotations on 04/10/02 21:26:26
------------------------------------------------------------------------------
---
This message is for the named person's use only.  It may contain This message 
is for the named person's use only.  It may contain confidential, proprietary, 
or legally privileged information.  No confidentiality or privilege is waived 
or lost by any mistransmission.  If you receive this message in error, please 
immediately delete it and all copies of it from your system, destroy any hard 
copies of it, and notify the sender.  You must not, directly or indirectly, 
use, disclose, distribute, print, or copy any part of this message if you are 
not the intended recipient.  Health First reserves the right to monitor all 
e-mail communications through its networks.  Any views or opinions expressed in 
this message are solely those of the individual sender, except (1) where the 
message states such views or opinions are on behalf of a particular entity;  
and (2) the sender is authorized by the entity to give such views or opinions.

==============================================================================