In general, any upgrades/downgrades done to a library require
you to halt TSM server and restart it to pick up the new info.

David LOngo

>>> Steve.Green AT MCCORMICK.CO DOT UK 04/08/02 08:16AM >>>
I have installed a second 18 slot column in to the Ultrium and from the control
panel
I can see and move a tape within it. However, when trying to checkin a tape
because
column one is full the TSM software does not know about column two and just
reads the
tape and then places it back in the bulk loader without even trying to place it
is column two.

Any ideas how to get TSM to see the second column.

Thanks - Steve



"MMS <health-first.org>" made the following
 annotations on 04/08/02 15:55:06
------------------------------------------------------------------------------
---
This message is for the named person's use only.  It may contain This message 
is for the named person's use only.  It may contain confidential, proprietary, 
or legally privileged information.  No confidentiality or privilege is waived 
or lost by any mistransmission.  If you receive this message in error, please 
immediately delete it and all copies of it from your system, destroy any hard 
copies of it, and notify the sender.  You must not, directly or indirectly, 
use, disclose, distribute, print, or copy any part of this message if you are 
not the intended recipient.  Health First reserves the right to monitor all 
e-mail communications through its networks.  Any views or opinions expressed in 
this message are solely those of the individual sender, except (1) where the 
message states such views or opinions are on behalf of a particular entity;  
and (2) the sender is authorized by the entity to give such views or opinions.

==============================================================================