With the  "LABEL LIBVOL"  command there is an option:
overwrite=yes.  This will write new label you specify even if a label exists.

My standard caveat on this is be careful as you can overwrite good
data tapes.

David Longo

>>> frigoulay AT BACKUPAVENUE DOT COM 02/19/02 11:46AM >>>
Hello in all

I collide has a problem of labelisation: I would like to change the label of
a cartridge being already in my robotics.

During the command{*order*} of LABEL, TSM reads the cartridge and realize
that this cartridge already possesses a label.

How to rewrite a label without the cartridge rose in the reader and read?

Thank you your good advices

Frédéric Rigoulay



"MMS <health-first.org>" made the following
 annotations on 02/19/02 12:09:38
------------------------------------------------------------------------------
---
This message is for the named person's use only.  It may contain This message 
is for the named person's use only.  It may contain confidential, proprietary, 
or legally privileged information.  No confidentiality or privilege is waived 
or lost by any mistransmission.  If you receive this message in error, please 
immediately delete it and all copies of it from your system, destroy any hard 
copies of it, and notify the sender.  You must not, directly or indirectly, 
use, disclose, distribute, print, or copy any part of this message if you are 
not the intended recipient.  Health First reserves the right to monitor all 
e-mail communications through its networks.  Any views or opinions expressed in 
this message are solely those of the individual sender, except (1) where the 
message states such views or opinions are on behalf of a particular entity;  
and (2) the sender is authorized by the entity to give such views or opinions.

==============================================================================