Re: Local DAT-Drive for UNLOADDB
2002-01-29 08:48:17
Hi
Have you checked to see if you have any outstanding request using the q req
command? Normally, this is the issue.
We're you placed at the macine when you did all of theese commands?
Normally, a manual library ejects the volume after a process has completed.
You didn't describe wethear or not you inserted the tape again.
Best Regards
Daniel Sparrman
-----------------------------------
Daniel Sparrman
Daniel Sparrman
Exist i Stockholm AB
Bergkällavägen 31D
192 79 SOLLENTUNA
Växel: 08 - 754 98 00
Mobil: 070 - 399 27 51
Christoph Pilgram
<[email protected] To: ADSM-L
AT VM.MARIST DOT EDU
LHEIM.COM> cc:
Sent by: "ADSM: Dist Stor Manager" Subject:
Local DAT-Drive for UNLOADDB
<ADSM-L AT VM.MARIST DOT EDU>
2002-01-29 14:41
Please respond to "ADSM: Dist Stor
Manager"
Hi all,
on my testserver (AIX 4.3.3 / TSM 4.14 ) I tried to get the local DAT-drive
as output-device for a test of unloaddb/loaddb going.
Defined a 'manuel library' called 'LOC_DEV'
Defined a 'manuel drive' called 'DAT1' pointing to '/dev/rmt0' with Library
Name 'LOC_DEV'
Defined a '4mm device class' called 'DAT' with 'recording format ' DDS3C',
'library name' = 'LOC_DEV'
Labelling a volume with 'label libvol LOC_DEV vol001' seems to work :
ANR2017I Administrator ADMIN issued command: LABEL LIBVOLUME LOC_DEV vol001
OVERWRITE=YES
ANR0984I Process 3 for LABEL LIBVOLUME started in the BACKGROUND at
14:24:40.
ANR8799I LABEL LIBVOLUME: Operation for library LOC_DEV started as process
3.
ANR8326I 002: Mount GENERICTAPE volume VOL001 R/W in drive DAT1 (/dev/rmt0)
of library LOC_DEV within 60 minutes.
ANR0609I LABEL LIBVOLUME started as process 3.
ANR8372I 002: Remove GENERICTAPE volume VOL001 from drive DAT1 (/dev/rmt0)
of library LOC_DEV.
ANR8800I LABEL LIBVOLUME for volume VOL001 in library LOC_DEV completed
successfully. ANR0985I Process 3 for LABEL LIBVOLUME running in the
BACKGROUND completed with completion state SUCCESS at 14:27:38.
Then I tried to make a dbbackup to the device class 'DAT', type 'FULL' on
volume 'vol001' an d got the following error :
ANR2280I Full database backup started as process 4.
ANR4571E Database backup/restore terminated - insufficient number of mount
points available for removable media.
ANR0985I Process 4 for DATABASE BACKUP running in the FOREGROUND completed
with completion state FAILURE at 14:28:57.
My question : where do I have to set the number of mountpoints other then
in
the the '4mm device class' or do I have enywhere else a wrong definition ?
Thanks for help
Chris
|
|
|