I am trying to restore selective directories from a backupset. The tape
is accessed, and prompt shows the correct node name, and also a counter
of bytes transferred. However this counter stays at zero. 

I am able to use the GUI to restore the WHOLE backup set with no
problems.

Using 4.2.0 NT client on the restore server and the production server.
Server is 4.2.1.6 NT


Using restore command:


dsmc restore backupset \\.\tape0 \\qbssnf11\c$\progra~1\* -loc=tape

It starts to restore, but the indictor is sitting at zero. I went to see
if the program files directory was being appended to and it was not.

I also searched the ADSM.org and used some of their suggestions with no
luck

Anything wrong with the above command?


Joe