> some time ago I complained in a mail to this list that the recovery log
> utilization is not reset after a database backup. APAR IC30181 was generated
> for this problem. Its status is "open".

I complained about the problem too. The response I got was, when the system was
too busy it took a while for it to happen.

I have done this when no sessions/processes were running on the system and it 
still
took over an hour to reset itself.

Our situation is worse as sometimes the log jumps up to over 90% before we 
start to
backup (triggered by a ANR0314W). It has continued to increase after the backup
and has got to 98% in one observed instance. Will it stop sessions if it gets 
to 100?

The reason we don't have a auto triggered backup is that we use a manual tape
drive (LTO is a bit of a waste for incrementals).

Suad
--
=========================================================================