Re: How to delete db volumes?
2001-05-11 13:24:20
The command defaults to midnight. So if the tapes were generated
after midnight they you have to say tot=now-0something, etc.
It won't let you delete the last one.
BTW : I noticed it will let you delete a full and then not its subsequent
INCR. BAD you could end up in a situation where you only have an INCR
to use for a restore and the FULL is GONE!!
Joseph A Faracchio, Systems Programmer, UC Berkeley
Private mail on any topic should be directed to :
joef AT socrates.berkeley DOT edu
On Fri, 11 May 2001, PINNI, BALANAND (SBCSI) wrote:
> Hi
>
> when the following cmd is given i get 0 volumes found but there are 4 db
> volumes tape volume is libv .
> By query libv i can see them and query volhist also i can see.
>
> >delete volhist type=dbbackup todate=today
>
> i get above message that 0 seqvolumes found.
> what is going wrong?
>
> pl help
> thanks in advance.
> BALANAND PINNI.
> PHONE 314-206-5911.
> EM:bp3965 AT momail.sbc DOT com.
> PG:1-800-451-6897.
>
>
|
|
|