Gerhard,

I'm seeing the same behavior on my system.  I haven't timed it so I don't know
how long it takes, but querying the DB / log status immediately after a DB
backup (we do mostly full backups) shows that the log hasn't been zeroed.
Sometime later it shows 0% utilized.  We went from ADSM 3.1 to TSM.   ADSM 3.1
zeroed the log immediately.

We are running TSM 4.1.2.0 on AIX 4.3.3.

Tab Trepagnier
(now) TSM Administrator
Laitram Corporation







Gerhard Rentschler <g.rentschler AT RUS.UNI-STUTTGART DOT DE> on 03/22/2001 
07:36:05 AM

Please respond to "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>

To:   ADSM-L AT VM.MARIST DOT EDU
cc:    (bcc: Tab Trepagnier/Corporation/Laitram/US)
Subject:  Recovery Log not reset after Incr. DB backup




Hi,
I frequently observe that the recovery log utilization is not reset
immediately after a full or incremental DB backup. It happens much later,
eg. 30 or 40 minutes after the backup finished. The last cases I watched no
sessions or processes were active after the backup finished. I opened a PMR
for this case. Has anyone else seen the problem?
My server is TSM 4.1.2.0 on AIX 4.3.3.
Best regards
Gerhard

---
Gerhard Rentschler            email:g.rentschler AT rus.uni-stuttgart DOT de
Gerhard Rentschler            email:g.rentschler AT rus.uni-stuttgart DOT de
Regional Computing Center     tel.   ++49/711/685 5806
University of Stuttgart       fax:   ++49/711/682357
Allmandring 30a
D 70550
Stuttgart
Germany