Hi,
I'm in the process of upgrading my STK library.  I currently have a STK9714
and I'm getting a STK9710.  Will I be able to move the tapes from on library
to another?  Or do I need to define another library, checkout the tapes from
the old STK9714 ( 100 tapes ) and check them in to the new library STK9714.
The libraries are very similar, the element numbers are the same!  I know
I'll need to verify the scsi address of the drives and I can make them the
same.  I should be able to cut over to the new library.
Are there any special configurations on the STK9710 like FAST LOAD, AUTO
CLEAN etc.  That should be set, does any one know?

I'm running TSM 3.7.4 on AIX 4.3.3.  With three scsi adapters.  The old
STK9714 has 6 DLT tape drive with 100 cells and the new STK9710 has 10 DLT
tape drive with 300 cells.

I know I'll need to define in AIX and TSM the additional tape drives.  But
I'm trying to see the easiest way to get the tapes over because I only have
ONE cap ( mailbox, in/out unit ).  It would be very time consuming to
checkout/checkin the 100 tapes from one library to another.

Thank you,
Laura
IMPORTANT:  The security of electronic mail  sent through the Internet
is not guaranteed.  Legg Mason therefore recommends that you do not
send confidential information to us via electronic mail, including social
security numbers, account numbers, and personal identification numbers.

Delivery, and timely delivery, of electronic mail is also not
guaranteed.  Legg Mason therefore recommends that you do not send time-sensitive
or action-oriented messages to us via electronic mail, including
authorization to  "buy" or "sell" a security or instructions to conduct any
other financial transaction.  Such requests, orders or instructions will
not be processed until Legg Mason can confirm your instructions or
obtain appropriate written documentation where necessary.