The q vol command will only give you information about storage pool
volumes, not scratch volumes.
Jim Sporer


At 07:55 AM 1/4/2001 -0600, you wrote:

I have eight volumes that are mounted in the tape library and when i run q
libv
they show up with a status of scratch and its blank under last use and it
gives
me a home element for the volume.

When I run a q vol XXXXXXX on the same volume number I get no response and it
should tell me that its readwrite etc, but doesn't.  Can anyone help me as to
what is going on.

Thanks,

Gene