ADSM-L

[no subject]

2015-10-04 17:27:37
üngliche Nachricht-----
> Von:  Andy Raibeck [SMTP:Andrew_Raibeck AT TIVOLI DOT COM]
> Gesendet am:  Dienstag, 12. September 2000 00:18
> An:   ADSM-L AT VM.MARIST DOT EDU
> Betreff:      Re: TSM 3.7.2 client on MS cluster
>
> Regarding the first issue (filespace \\node2\t$ being
> created): this is correct. The filespace name is based
> on the UNC name of the drive, which in turn is based on
> the machine name. So if the machine name is NODE2, then
> \\node2\t$ is the correct filespace name.
>
> On the second issue: As Arturo mentioned, we are
> investigating this.
>
> Regards,
>
> Andy
>
> Andy Raibeck
> IBM/Tivoli
> Tivoli Storage Manager Client Development
> e-mail: andrew.raibeck AT tivoli DOT com
> "The only dumb question is the one that goes unasked."
>
> I have this same problem, I have opened up a problem with TIVOLI.  I can
> restore from the command line without problems, but from the GUI I can
> only
> restore from the file level.  I cannot restore from the root level or
> folder
> level.....
>
> Good luck They are suppose to be working the problem.
>
> Arturo
>
>         -----Original Message-----
>         From:   Rupp Thomas (Illwerke) [SMTP:thomas.rupp AT ILLWERKE DOT AT]
>         Sent:   Sunday, August 27, 2000 10:44 AM
>         To:     ADSM-L AT VM.MARIST DOT EDU
>         Subject:        TSM 3.7.2 client on MS cluster
>
>         Hi TSM-gurus,
>
>         I'm running TSM client 3.7.2 on a MS Windows NT 4.0 cluster.
>         When I start the GUI with "DSM -optfile=T:\adsm\dsm.opt"
>         (the same optfile is used by the scheduler) I get the following
> two
>         problems:
>
>         - On backup TSM creates a filespace using the wrong name. As the
>           nodename is "DATEN" and the name of the machine is "NODE2" TSM
>           should create a filespace named "\\DATEN\T$" but the GUI creates
>         "\\NODE2\T$".
>         - On restore I can only select single files, no directories. When
> I
> remove
>         "CLUSTERNODE YES"
>           from DSM.OPT this problem vanishes.
>
>         I think I'll have to specify the /clustername when I start the GUI
> -
> but I
>         don't know how!
>         How do you start the GUI on a MS cluster and/or have you seen this
> behavior?
>
>         Thanks in advance!
>
>         Kind regards
>         Thomas Rupp
>         Vorarlberger Illwerke AG
>         MAIL:   thomas.rupp AT illwerke DOT at
>         TEL:    ++43/5574/4991-251
>         FAX:    ++43/5574/4991-820-8251

--0__=XJzB7wnDSCFD2mlwQ4QBPGtY2hyFCNcnxeRUJL5XlT3vWaUEmiIM2euy--
=======================================================================
<Prev in Thread] Current Thread [Next in Thread>
  • [no subject], Unknown <=