Invoking DSMC via at command
2000-07-07 14:14:35
Trying to issue the command dsmc incr from an at command on NT. It's a long
story but I can't use the standard scheduler service. I issued the set
commands to setup the environment variables but I'm getting the following
error when the bat file is started via at:
ANS0101E NLInit: Unable to open message repository 'dscameng.txt'.
If I run the same bat file from a DOS prompt it runs fine.
Obviously I don't understand everything I should about at. Does anyone have
an example of doing this?
Curt Magura
Lockheed Martin EIS
Gaithersburg, Md.
301-240-6305
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Invoking DSMC via at command,
Magura, Curtis <=
|
|
|