MKSYSB Failure After TSM Install
2000-03-30 02:01:14
All,
I ran the command mksysb -i -X /dev/rmt0 and received
the following messages:
Creating information file (/image.data) for rootvg.....
Creating tape boot image./dev/rmt0.1: There is a request
to a device or address that does not exist.
0512-044 mksysb: Cannot access device /dev/rmt0.1.
tctl retension failed with return code 2.
The box is a 4.3.3 7248-43P with an external IBM
7206-005 DDS-2 4GB tape drive. And yes I have verified
that the special files rmt0 and rmt0.1 are present
in the dev dir.
This is a brand new machine EXCEPT that it has a 3.7.2.0
TSM server on it and I am also using the same tape drive
for local TSM backups. So in order to use the 4mm tape
drive I had to go into smit and define a TSM tape drive on
top of the rmt drive. Of course I have already tried
deleting the entire TSM drive including the special files
to no avail. And I have even delete all the definitions
ran cfgmgr and also rebooted, but nothing seems to allow
me to get a good mksysb.
Any ideas?
--
Joshua S. Bassi
Joshua S. Bassi
Senior Technical Consultant
Symatrix Technology, Inc.
jbassi AT gloryworks DOT com
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- MKSYSB Failure After TSM Install,
Joshua S. Bassi <=
- Re: MKSYSB Failure After TSM Install, S W Branch
- Re: MKSYSB Failure After TSM Install, Joshua S. Bassi
- Re: MKSYSB Failure After TSM Install, Cook, Dwight E
- Re: MKSYSB Failure After TSM Install, Alessio Prodon
- Re: MKSYSB Failure After TSM Install, Scott Pond
- Re: MKSYSB Failure After TSM Install, S W Branch
- Re: MKSYSB Failure After TSM Install, Morris.Marshael
- Re: MKSYSB Failure After TSM Install, Cook, Dwight E
- Re: MKSYSB Failure After TSM Install, Joshua S. Bassi
- Re: MKSYSB Failure After TSM Install, Joshua S. Bassi
|
|
|