Re: Tape mounts
2000-03-09 14:56:06
Good Morning John,
I just resolved why we saw something similar.
q proc
shows two processes using one tape each
Yet
q mount
shows four tapes in use
q vol <volume>
gave me the clue
I found the tape pool that the volumes were in
Then looked and sure enough there were two direct to tape sessions running to
that pool
q session
Hope this helps
Bear
"Doherty, John (ANFIS)" wrote:
> Can anyone tell me why the following would happen:
>
> I am running 2 processes, a backup of a storage pool and one reclamation
> process, these 2 processes are using 4 tapes, but when I do a 'Q Mount'
> command I see 6 tapes mounted and in use to ADSM. There are 2 tapes mounted
> and in use. But i do not know where or why these other 2 tapes are being
> used ? Is there any way in knowing what is using these tapes?
>
> Can anyone shed any light on this, for example does ADSM use tapes and keep
> them mounted until a process is finished.
>
> Thanks in advance
>
> > John Doherty. Tel: +44 (0) 141 275 7793
> > Fax: +44 (0) 141 275 9199
> > Email: JDohe1 AT Anfis.co DOT uk
> >
> > Technical Specialist, Storage Management L02S
> >
> > Email communications are not necessarily secure and may be intercepted or
> > changed after they are sent. Abbey National Financial and Investment
> > Services does not accept liability for any such changes. If you wish to
> > confirm the origin or content of this communication, please contact the
> > sender using an alternative means of communication. This communication
> > does not create or modify any contract. If you are not the intended
> > recipient of this communication you should destroy it without copying,
> > disclosing or otherwise using its contents. Please notify the sender
> > immediately of the error.
> >
> > ABBEY NATIONAL FINANCIAL AND INVESTMENT SERVICES plc
> > Registered Office Abbey National House 287 St Vincent Street
> > Glasgow G2 5NB United Kingdom Registered in Scotland No 159852
> >
|
|
|