Collocation
2000-02-15 10:45:12
Hi *SM-ers!
I'm currently using collocation for all my nodes. I found out that a lot of
them are just using one tape and thus turning off collocation for them would
be wise.
So I created a non-collocated primary tape pool for them and since I do not
want clients to backup directly to tape I also created a diskpool which has
the non collocated tapepool as next pool.
Now my problem: When I want to backup to this new diskpool I have to create
disk pool volumes for this diskpool, using the dsmfmt tool. I tried adding
the disk volumes I already use in the collocated diskpool to the
non-collocated diskpool, but that's not allowed by ADSM.
Does this mean that you cannot use the same physical disk volumes for both
collocated as non-collocated data? If that's the case, I will have to split
up my (already small) physical disk pool!
Am I overlooking something simple here?
Thanks in advance for any reply!
Kindest regards,
Eric van Loon
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Collocation,
Loon, E.J. van - SPLXM <=
- Re: Collocation, Paul Zarnowski
- Re: Collocation, Loon, E.J. van - SPLXM
- Re: Collocation, Steven P Roder
- Re: Collocation, Nick Cassimatis
- Re: Collocation, Bill Colwell
- Re: Collocation, Paul Zarnowski
- Re: Collocation, Loon, E.J. van - SPLXM
- Re: Collocation, Steven P Roder
- Re: Collocation, Bill Colwell
- Re: Collocation, Bill Colwell
|
|
|