Yes, Andy Raiback reminded me not so long ago that the readme files
tell you how to unpack the files ...
Installation instructions:
1) Extract the installation image by executing the following
command:
IP21618.BAT target
"target" is the directory where you would like the
installation
image to reside.
and in the bat file referred to above you will find the following:
echo Extracting the install image
echo ----------------------------
IP21618.FULL.EXE -d %1
This helped me the last time I forgot to use the bat file, thanks Andy.
Eric
______________________________ Reply Separator
_________________________________
Subject: Re: ADSM Client 3.1.0.7 on WinNT
Author: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> at IPNET
Date: 11/19/99 10:14 PM
Hello,
I believe this could be the result of exploding the zip file by clicking on
in from the windows explorer. When you do this, the exploded files will
all go into a single directory when in actual fact, there should be several
subdirectories created.
I suggest you delete all of the exploded files and start again. This time,
try this.
open an MS-DOS prompt window
cd to the directory where the .ZIP file is
use pkunzip with the -d flag to unzip the file. The -d flag will
restore the directory structure that is stored on the .ZIP file.
After doing so, check the directory. You should see several subdirectories
created/restored. If you do then go ahead and run
the setup.exe.
you probably can do the same thing (restoring directory structures) using
winzip, but I don't know how.
Hope this helps.
Sara
RS/6000 Support & Professional Services,
IBM Malaysia
Level 6, Plaza IBM
Tel: 6-03-7177788 Ext 2963
"Springer Friedrich VASL/FAI" <Friedrich.Springer AT VOEST.CO DOT AT> on
11/19/99
05:42:30 PM
Please respond to "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
To: ADSM-L AT VM.MARIST DOT EDU
cc: (bcc: Raja Sara Raja Uda Al-Khal/Malaysia/IBM)
Subject: ADSM Client 3.1.0.7 on WinNT
Hi,
I am an ADSM User from MVS to now WinNT. We use ADSM Rel 3.1.0.6
A few days before I tried to install the new ADSM Client Rel 3.1.0.7. After
reloading the Release
from Internet I deflated it and called SETUP.EXE.
I got the error message :
Setup is unable to find _SETUP.DLL, which is needed to complete the
installation.
Error 103
I looked in the installation directory and found _setup.dll . I asked the
WinNT specialist, but in vain.
Also the IBMer do not know a solution!?
Who can help me?
|