Testing Tapes in 3570
1998-12-10 15:08:59
Hi!
Since we experienced many problems with our NT attached 3570 during the
last weeks (tension lost, defective tapes etc. etc.) I'd like to make sure
that after replacing some tapes and having the IBM CE in several times
everything is working properly. So I currently use "move data" commands to
copy data from one tape to another (using a disk pool as a "buffer" since I
habe only one tape drive available).
My question is if there is any other recommended way to check/verify my
tapes and assure that the drive and lib is working properly. I am looking
for a command the "searches" all over a tape - like a "dummy" restore for
example. Can somebody share her/his experiences with me?
Mit freundlichem Gruss/Best Regards
Michael Abel
IBM Certified Advanced Technical Expert - RS/6000 AIX
IBM Certified Specialist - ADSM
=====================================================
res nova Unternehmensberatung GmbH
...aktiv in AIX
MAIL: Ruppmannstrasse 41
D-70565 Stuttgart, Germany
FON: +49 711 78888 0
FAX: +49 711 78888 99
WWW: http://www.resnova.de
EMAIL: mailto:Michael.Abel AT resnova DOT de
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Testing Tapes in 3570,
Michael Abel <=
|
|
|