Re: 3590 tape library not seeing drives
1998-06-23 18:22:01
Subject: |
Re: 3590 tape library not seeing drives |
From: |
"Campbell, Rose" <campbelr AT JNTF.OSD DOT MIL> |
Date: |
Tue, 23 Jun 1998 16:22:01 -0600 |
Dwight,
Thanks for the help. When I do a show libr online=0 on 2 of my 3 drives. I
have checked the errpt but there are no error on the drives. Is there some
other place I should be looking? Sorry for my ignorance in this, but this
is the first time we have come across this problem.
Again thanks for all the help.
Rose Campbell
> -----Original Message-----
> From: Dwight Cook [SMTP:decook AT AMOCO DOT COM]
> Sent: Tuesday, June 23, 1998 10:00 AM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: 3590 tape library not seeing drives
>
> Are you seeing any "library sequence check errors" ?
>
> Also you can do a "show libr" from a dsmadmc session... look for
> "online=1" which means all is ok... "online=0" is an indication you
> probably have an error displayed on the drive...
>
> do a "q stg pool_using_3590 f=d" and check the max scratch count and
> make sure you are not at that limit....
>
> ALSO, for each node's data in a diskpool there will only be a single
> migration process initiated... that is if your diskpool has 100 GB of
> data, all from the same node it doesn't matter how many mount points
> or migration processes you've set there will only be one!
>
> also from aix you can do a "lsdev -Cc tape" to get the "lmcp#"
> (ex lmcp0)
> then use the lmcp# in the "mtlib -l/dev/lmcp# ..." to find out misc
> stuff as to what the heck is going on... use "mtlib -?" to see the
> syntax of available commands and what relate to...
>
> hope this helps
> later,
> Dwight
>
>
>
> ______________________________ Reply Separator
> _________________________________
> Subject: Re: 3590 tape library not seeing drives
> Author: CBRM (CBRM AT argushealth DOT com) at unix,mime
> Date: 6/23/98 9:42 AM
>
>
> Are all three drives available if you look on the library's console?
> Query devc. Make sure the mount limit for the device class is 3.
> -Bob-
>
> >>> "Campbell, Rose" <campbelr AT JNTF.OSD DOT MIL> 06/23/98 09:11AM >>>
> Hi all,
>
> We are running ADSM v2 on AIX v4.1.4, attached to a 3590 tape library with
> 3
> tape drives. Lately we have been having a lot of problems with the
> library,
> the latest is that it is only using 1 of the 3 tape drives. Everything
> appears to be correct, the number of mount points is 3 and the devices are
> all defined.
>
> Does anybody know why ADSM would only be using one of the drives instead
> of
> all 3?
>
> Rose M. Campbell
> Data Storage Manager
> Joint National Test Facility
> > Schriever AFB
> 720 Irwin Avenue
> Colorado Springs, CO 80912-7300
> 719-567-8454
> Internet mail address:
> rose AT jntf.osd DOT mil
>
>
>
>
>
>
>
>
>
>
>
>
> !
|
|
|