Thanks. I was not aware of that approach.

Mark A. Adams
UNIX SYSTEMS ADMINISTRATOR
(402) 963-7369 Office
(402) 444-0754 Pager
Communications Marketing Services
SITEL Corporation
7444 Farnam
Omaha, NE 68114

>-----Original Message-----
>From:  Pittson, Timothy ,HiServ/NA [SMTP:tpittson AT HIMAIL.HCC DOT COM]
>Sent:  Monday, October 06, 1997 10:23 AM
>To:    ADSM-L AT VM.MARIST DOT EDU
>Subject:       Re: ADSM Collocation questions ??
>
>Mark,
>        You can use the MOVE DATA command to move data from tape back to your
>disk storagepool... next time migration runs, the data gets collocated.
>This will take some time but works well.  The other alternative is to do
>an EXPORT NODE ... filedata=all, delete the node, then do an IMPORT
>NODE.
>
>Regards...
>Tim Pittson
>
>>----------
>>From:  Mark Adams[SMTP:madams AT CSG.SITEL DOT NET]
>>Reply To:      ADSM: Dist Stor Manager
>>Sent:  Friday, October 03, 1997 11:08 AM
>>To:    ADSM-L AT VM.MARIST DOT EDU
>>Subject:       Re: ADSM Collocation questions ??
>>
>>It will not collocate the data
>>
>>Mark A. Adams
>>UNIX SYSTEMS ADMINISTRATOR
>>(402) 963-7369 Office
>>(402) 444-0754 Pager
>>Communications Marketing Services
>>SITEL Corporation
>>7444 Farnam
>>Omaha, NE 68114
>>
>>>-----Original Message-----
>>>From:  Steven P Roder [SMTP:tkssteve AT ACSU.BUFFALO DOT EDU]
>>>Sent:  Friday, October 03, 1997 8:49 AM
>>>To:    ADSM-L AT VM.MARIST DOT EDU
>>>Subject:       Re: ADSM Collocation questions ??
>>>
>>>On Fri, 3 Oct 1997, Mark Adams wrote:
>>>> The only way I know of is to restore and backup again
>>>>
>>>> >If I decide today to set Collocation on (by node or by a filespace)
>>>> >at my stgpools is there a way to get old data collocated also ??
>>>
>>>Wouldn't "move data vsn" do the trick?
>>>
>>>Steve (unVMix Systems Programmer/Dude) Roder
>>>(tkssteve AT ubvm.cc.buffalo DOT edu | tkssteve AT acsu.buffalo DOT edu | 
>>>(716)645-3564 ,
>>>   | http://ubvm.cc.buffalo.edu/~tkssteve)
>>