pkgadd worked with the complete pathname. The install went
fine. I edited the dsm.opt and dsm.sys and it took right
off.
>
> You're right, this was supposed to be corrected a long
> time ago. The problem with the NCR package on the FTP
> server is twofold:
>
> 1.) It is not compressed, even though it has the .Z
> extension.
>
> 2.) The README contains an error in the installation
> instructions:
> "pkgadd -d ./IP20992.pkg" should read "pkgadd -d
`pwd`/IP20992.pkg"
> because the pkgadd utility requires the absolute path to
> the installation package.
>
> Sorry about these problems, I'll have them fixed ASAP.
>
> Regards,
>                      Christian
>
> > I downloaded the AT&T client from ftp.cac.psu.edu but
could
> > not install it.
> >
> > 1) It claimed to be compressed, but wasn't.
> > 2) When I tried running it through pkgadd anyway I get:
> > Installation in progress.  Do not remove the
installation
> > media.
> >
> > pkgadd: ERROR: attempt to process datastream failed
> >     - open of <att_v2r1m6_IP20992_pkg> failed, errno=2
> > pkgadd: ERROR: could not process datastream from
> > <att_v2r1m6_IP20992_pkg>
> >
> > Does anyone have any gueses about where to get a good
> > package for NCR/AT&T unix 2.3?
> >
> > Thanks,
> > Kai.
>
> Christian Bolik
> IBM SM IT Software Development ADSM
> Dpt. 0005, Mainz, Germany, 55131-72