Re: Data migration
1996-04-25 11:03:52
Automatic digest processor <LISTSERV AT VM.MARIST DOT EDU> writes:
> Date: Wed, 24 Apr 1996 08:57:53 PDT
> From: "Andrew M. Raibeck" <araibeck AT VNET.IBM DOT COM>
> Subject: Re: Data migration
>
> Jeffrey Mathers asks:
>
> >A user performed an archive job without mounting a tape in the drive. The
> >migration threshold was passed, but since there was no tape mounted the
> >migration never occurred. How can I now migrate the data from the disk
> >pool to the tape?
>
> Issue the UPDATE STGPOOL command to reduce your low and high migration
> thresholds. This should cause migration to kick in.
>
> Don't forget to reset them to their original values, after.
>
> Andy Raibeck
> ADSM Level 2 Support
> 408-256-0130
You can use the same setting that they already are at to give the migration
a kick start. For instants, if hi is at 60 then you can just run:
upd stg <stgpool> hi=60
Just the mere fact that you updated something (even if you didn't really change
anything) should be enough.
Chuck T.
(Not ADSM Support)
|
|
|