Author: Vergakis Costas <C.Vergakis AT asyk.ase DOT gr>
Date: Fri, 25 May 2001 02:29:32 -0500
Hi all, i wonder if anyone could help me with this. I have loaded the following MIBs and the related traps: cisco-isdn-mib-v1smi.my cisco-isdnu-if-mib-v1smi.my But, in spite of this, i'm getting the
There are lots of appends about this- loading a MIB doesn't configure the trap in trapd.conf. To add a single trap, use xnmtrap, or bring it up Options->Event configuration-> Trap customization and a
When you say that you have loaded the related Traps, what exactly do you mean? The mib file may have trap definitions in it, but that does not enable Netview to format them. For that you have to eith
Author: Costas Vergakis <vergakis AT yahoo DOT com>
Date: Tue, 29 May 2001 00:30:23 -0700 (PDT)
Hi Leslie, thank you for your response. What I mean is that I've loaded the traps using the mib2trap command, created and run the script, but the specific 3 trap not included in the MIB specification
If the specific 3 trap for that enterprise is not in the MIB then you must format it manually or go find the MIB which defines it. Have you tried looking out on the Cisco website for the right MIB? I
Author: William.Stringfellow AT bankofamerica DOT com
Date: Tue, 29 May 2001 13:03:20 -0700
Vergakis, The MIB you loaded should give you a readable output IF you run mib2trap cisco-isdn-mib-v1smi.my OUTPUTFILENAME and than execute the OUTPUTFILENAME that is actually a script to load the tra