Author: Luke Salsich <luke.salsich AT gmail DOT com>
Date: Wed, 28 Jun 2017 13:23:46 -0400
Hello everyone, I'm really struggling to solve a problem with my bacula setup and I could use some guidance or helpful comments, PLEASE PLEASE. I've been using Bacula for about six months with an AWS
Hello, Try reading the Object Store white paper posted on the web site. It discusses the use of the AWS storage gateway. Best regards, Kern On 06/28/2017 07:23 PM, Luke Salsich wrote: Hello everyone,
Luke, This usually happens when the path to the device in Bacula does not line up with the OS. For each drive one at a time, mount a volume in bconsole and verify with mtx status that it is where it
Author: Luke Salsich <luke.salsich AT gmail DOT com>
Date: Wed, 28 Jun 2017 15:20:28 -0400
Luke, This usually happens when the path to the device in Bacula does not line up with the OS. For each drive one at a time, mount a volume in bconsole and verify with mtx status that it is where
Author: Luke Salsich <luke.salsich AT gmail DOT com>
Date: Wed, 28 Jun 2017 19:57:30 -0400
Luke, This usually happens when the path to the device in Bacula does not line up with the OS. For each drive one at a time, mount a volume in bconsole and verify with mtx status that it is where
Hello, It seems to me that there is at least one problem in the output below -- most likely indicating configuration problems. See comments below ... On 06/29/2017 01:57 AM, Luke Salsich wrote: OK, s
Author: Luke Salsich <luke.salsich AT gmail DOT com>
Date: Thu, 29 Jun 2017 11:07:58 -0400
Hi Kern, Thanks for the reply. The " Specified slot ignored." error was my fault - I tried to mount to a drive which was already loaded. I did run through those steps again with success, but copied t
Author: Ana Emília M. Arruda <emiliaarruda AT gmail DOT com>
Date: Sun, 16 Jul 2017 21:48:49 -0300
Hello Luke, I noticed you are using "/dev/tape/by-path/" for the tape drives archive device configuraton. It is safer to use "/dev/tape/by-id" to avoid tape drives be twisted after server reboots, f
Author: Luke Salsich <luke.salsich AT gmail DOT com>
Date: Mon, 17 Jul 2017 09:53:17 -0400
Hi Ana, Thanks for your thoughts! I thought I was using a safe approach to device configuration, but your comments make me rethink this. I will revisit this today. Much appreciated. Thanks so much, -