We have a tape that is off site which we can't seem to bring back onsite through the normal processes. The tape was reclaimed yesterday, but has a status of FULL although utilization is at 0 and recl
We've seen this before ourselves. Usually the reason is that we have a parameter(re-use delay period) set so that even though the information on these tapes has been moved to other tapes by ADSM, the
Author: Francisco Molero <fmolero AT YAHOO DOT COM>
Date: Tue, 18 Jan 2000 11:22:04 -0800
Hi Ted, Maybe you can run an audit volume command -- __________________________________________________ Do You Yahoo!? Talk to your friends online with Yahoo! Messenger. http://im.yahoo.com
If the REUSEDLAY were set to other than 0, the volume should be in a pending state. The parameter is set to 0 for the storage pool. The other volume that was reclaimed at the same time went immediate
Author: Ray Baughman <rbaughman AT NATIONALMACHINERY DOT COM>
Date: Tue, 18 Jan 2000 14:43:39 -0600
Try to move the data from the tape. Sometimes a move data and reclaim may not move all the data from the tape the first time, however a second move data usually corrects the problem. Ray Baughman Nat
Per Ray Baughman & Dwight Cook, I've tried moving the data (several times), but... ANR2017I Administrator TBYRNE issued command: MOVE DATA d00082 ANR2209W Volume D00082 contains no data. ANR2017I Adm
Author: Russell Street <russells AT AUCKLAND.AC DOT NZ>
Date: Wed, 19 Jan 2000 10:35:20 +1300
I have found that running an "audit volume XXXX fix=yes" on the volume brings it back into line. The audit process prints a message about correcting the volume information. The tape is then set to EM
Author: Steven P Roder <tkssteve AT REXX.ACSU.BUFFALO DOT EDU>
Date: Tue, 18 Jan 2000 17:09:44 -0500
Yes, and I would recommend against allowing it to go into STGREUSE. That is, re-mark it offsite until the reuse period on the storage pool expires, and then do a "delete vol xxxx" to force it to go
Ted, Could be bad news. I had similar problems with 4 tapes and we ended up discovering that we have data base errors. If the Audit Volume doesn't work for you then the only alternative is Audit DB.