Hi, I have put specific IP adresses on the seed file to force NV to discover them but even though that the host does not appear in the maps. Only the host that are in the local subnet are discovered(
Iņaki, if you configure in your Netview "Options -> Topology/Status and Polling..." as follows: Enable Polling and Discovery Settings ON ... Discover New Nodes OFF => will discover the nodes listed i
Author: Jane Curry <jane.curry AT skills-1st.co DOT uk>
Date: Wed, 08 Oct 2003 09:53:17 +0100
Can you ping these addresses in your seedfile? Do you have more than one NetView map (Use the File -> Open Map menu to see what maps you have). You can use the ovobjprint command to see everything in
I am running NV 7.1.3 on Windows 2000. The only map that I have is the default one (root, IP Internet). I can ping the hosts specified on the seed file, and NV does not discover them. However there c
Author: "John M Gatrell" <John.Gatrell AT uk.ibm DOT com>
Date: Fri, 10 Oct 2003 09:30:03 +0100
Have you installed the service pack NV713FP1? John Gatrell, B.A. Physics, CCNA RMSC - IBM UK's Remote Managed Services Centre Tel: 0870-010-6284 Internal 814732
Author: "Erdey, Raymond M" <Raymond.M.Erdey AT erac DOT com>
Date: Fri, 10 Oct 2003 08:00:12 -0500
Inaki, Do you have any "Negative Entries" in your seed file? Here is an example of a negative entry: !@oid 0 Do you have any networks defined in your seed file? Example: 192.168.1.* The above will se
Hi, I already installed the patch. However the problem with the discovery was that SNMP packets were beign filtered. Even when I could reach the hosts with ICMP they never where discovered (ovobjprin