1. Community Tip: Please Give Thanks to Those Sharing Their Knowledge.
    If you receive helpful answer on this forum, please show thanks to the poster by clicking "LIKE" link for the answer that you found helpful.
  2. Community Tip: Forum Rules (PLEASE CLICK HERE TO READ BEFORE POSTING)
    Click the link above to access ADSM.ORG Acceptable Use Policy and forum rules which should be observed when using this website. Violators may be banned from this website. This notice will disappear after you have made at least 3 posts.

TSM V7.1 BACLIENT CONFIGURATION ON AIX

Discussion in 'TSM Client' started by waz, Jun 2, 2016.

  1. waz

    waz ADSM.ORG Member

    Joined:
    Jun 2, 2016
    Messages:
    11
    Likes Received:
    0
    Hello,

    I m new in TSM.

    Im preparing a tqm maquette but i have some problems. I installed TSM server V7.1.4 and opertaions centers on a windows server 2012 VM (Named: TSMSRV).
    An I depolyed tsm ba client V7.1 (and pi) on an AIX server V7.1 (SRVAIX7). The default installation directory is: /usr/tivoli/tsm/client/ba/bin64
    I created in this directory dsm.opt and dsm.sys files and I modified them as presented below :
    upload_2016-6-2_10-41-53.png

    and I add this section to etc/profile file :
    upload_2016-6-2_10-44-5.png

    I want to know if I should point by the DSM_Config to dsm.opt or dsm.sys. tried to point it to dsm.sys but i hva those error message :

    upload_2016-6-2_10-53-5.png


    When I point it on dsm. opt(DSM_CONFIG=/usr/tivoli/tsm/client/ba/bin64/dsm.opt) oand I try to open web client : http://srvaix_ip:1581 I have nothing ???

    how to correct config is correct ,who to set aix environments variables and how to configure aix web client ???

    Thanks in advance.
     
  2.  
  3. marclant

    marclant ADSM.ORG Moderator

    Joined:
    Jun 16, 2006
    Messages:
    2,462
    Likes Received:
    346
    Occupation:
    Accelerated Value Specialist for Spectrum Protect
    Location:
    Canada
    You have to point DSM_CONFIG to the .opt file (doesn't need to be dsm, but it needs to be an opt file).

    And in dsm.opt, you need to have a servername option that specifies the same as the server stanza you want to use in dsm.sys. In your case dsm.opt would look like:
    Code:
    servername TSMSRV
    If you had more than one servername in dsm.sys, then you would specify the one you want to use by default.
     
    waz likes this.
  4. DazRaz

    DazRaz ADSM.ORG Senior Member

    Joined:
    Jun 15, 2008
    Messages:
    143
    Likes Received:
    12
    And for the webclient to work, you will need to start the Client Acceptor Daemon.

    dsmcad &

    should do it.
     

Share This Page