1. Community Tip: Please Give Thanks to Those Sharing Their Knowledge.
    If you receive helpful answer on this forum, please show thanks to the poster by clicking "LIKE" link for the answer that you found helpful.
  2. Community Tip: Forum Rules (PLEASE CLICK HERE TO READ BEFORE POSTING)
    Click the link above to access ADSM.ORG Acceptable Use Policy and forum rules which should be observed when using this website. Violators may be banned from this website. This notice will disappear after you have made at least 3 posts.

Reclamation Processes

Discussion in 'Backup / Archive Discussion' started by fabio.ety, Nov 17, 2005.

  1. fabio.ety

    fabio.ety Newcomer

    Joined:
    Nov 17, 2005
    Messages:
    1
    Likes Received:
    0
    Hi to all,...

    does anybody know a good way to limit the reclamation proc that runs at the same time.

    I wish to prevent that all of my mount point will be used for may hours a day....



    :confused:
     
  2.  
  3. heada

    heada ADSM.ORG Moderator

    Joined:
    Sep 23, 2002
    Messages:
    2,560
    Likes Received:
    168
    Occupation:
    Storage Administrator
    Location:
    Indiana
    Set your reclamation threshold to 100. When you want to run reclaims, set it to the number you normally keep it at (i.e. 80) Let reclamation run until you want it stopped. Set it back to 100 and cancel the processes.



    This will restrict it to run only when you want it to run, but you'll probably have issues with too many tapes getting fragmented.



    Good luck.



    -Aaron
     
  4. jmcallis

    jmcallis ADSM.ORG Member

    Joined:
    Sep 9, 2003
    Messages:
    32
    Likes Received:
    0
    Location:
    CA
    I'd do it as the previous post suggests and schedule it in a administrative schedule running reclaimation during idle time.
     

Share This Page