1. Community Tip: Please Give Thanks to Those Sharing Their Knowledge.
    If you receive helpful answer on this forum, please show thanks to the poster by clicking "LIKE" link for the answer that you found helpful.
  2. Community Tip: Forum Rules (PLEASE CLICK HERE TO READ BEFORE POSTING)
    Click the link above to access ADSM.ORG Acceptable Use Policy and forum rules which should be observed when using this website. Violators may be banned from this website. This notice will disappear after you have made at least 3 posts.

Find space used on a tape : MSL5000

Discussion in 'Tape / Media Library' started by jpmill, Feb 21, 2012.

Thread Status:
Not open for further replies.
  1. jpmill

    jpmill Newcomer

    Joined:
    Feb 21, 2012
    Messages:
    4
    Likes Received:
    0
    Hi,

    I have just taken a dump of a couple of mount point on my tape and I want to know how much space it has taken.

    I didn't find any "mtx" command to do that.


    Is there a way to know that?

    Thank you

    jp
     
  2.  
  3. unixandtsm

    unixandtsm ADSM.ORG Member

    Joined:
    Feb 9, 2011
    Messages:
    307
    Likes Received:
    0
    q volume volume_name
     
  4. jpmill

    jpmill Newcomer

    Joined:
    Feb 21, 2012
    Messages:
    4
    Likes Received:
    0
    I'm not sure to understand.

    I'm on REHL, I have a tape (MSL5000) with my data on. I dont understand where to type this command.

    I did an "mtx status" command and I see my volume in a slot. VolumeTag=xxxxxxx

    But where can I run command against my librairie?
     
  5. jpmill

    jpmill Newcomer

    Joined:
    Feb 21, 2012
    Messages:
    4
    Likes Received:
    0
    I'm not on tivoli sorry
     
: left, msl5000, space, tape
Thread Status:
Not open for further replies.

Share This Page