1. Community Tip: Please Give Thanks to Those Sharing Their Knowledge.
    If you receive helpful answer on this forum, please show thanks to the poster by clicking "LIKE" link for the answer that you found helpful.
  2. Community Tip: Forum Rules (PLEASE CLICK HERE TO READ BEFORE POSTING)
    Click the link above to access ADSM.ORG Acceptable Use Policy and forum rules which should be observed when using this website. Violators may be banned from this website. This notice will disappear after you have made at least 3 posts.

DIRMC STGPOOL Recovery - Question

Discussion in 'Disaster Recovery Module' started by buster99, Mar 29, 2016.

  1. buster99

    buster99 ADSM.ORG Member

    Joined:
    May 14, 2008
    Messages:
    124
    Likes Received:
    0
    Hello, I wanted to see if I could get confirmation that I have the correct expectations of a recovery step for an upcoming DR test. We have a DIRMC stgpool that would normally take a few days to restore, but since our last DR test we have added it to our replicated line between our office and our DR site. It goes from the a "live" XIV storage unit to the DR XIV storage unit. I think we have older versions of TSM on our minds when we wonder if the DIRMC stgpool or volumes will need to be renamed at DR before using them. I don't think they will have to be renamed but wanted to check. Thank you
     
  2.  
  3. moon-buddy

    moon-buddy ADSM.ORG Moderator

    Joined:
    Aug 24, 2005
    Messages:
    6,769
    Likes Received:
    352
    Occupation:
    Electronics Engineer, Security Professional
    Location:
    Somewhere in the US
    If the the DR setup mirrors the PROD, then no renaming is needed.
     
  4. buster99

    buster99 ADSM.ORG Member

    Joined:
    May 14, 2008
    Messages:
    124
    Likes Received:
    0
    Thank you for the quick reply.
     

Share This Page