crooked
ADSM.ORG Member
Hey folks, anyone know of the best command to run to find out the hosts affected by a node failure on an SVC?
-
-
Community Tip: Forum Rules (PLEASE CLICK HERE TO READ BEFORE POSTING)
Click the link above to access ADSM.ORG Acceptable Use Policy and forum rules which should be observed when using this website. Violators may be banned from this website. This notice will disappear after you have made at least 3 posts.
Determine hosts affected on SVC
- Thread starter crooked
- Start date
Castaway
ADSM.ORG Member
Well, a node failure should not have an impact if the zoning is correct. An IO Group has 2 nodes so, if you've zoned the server to each of the nodes of an IO group, one of the nodes going down should have no impact. Me thinks there's more to this story?
rore
ADSM.ORG Senior Member
Castaway,
that is correct IF you have the proper multipath software configured on your hosts.
Crooked,
What do you mean by 'affected'?
I/O failover? (no interruption)
I/O interrupted?
that is correct IF you have the proper multipath software configured on your hosts.
Crooked,
What do you mean by 'affected'?
I/O failover? (no interruption)
I/O interrupted?
