We are implanting a design in a customer who possesss the following one
configuration:
-SP RS/6000 System
-MAGSTAR 3570-MP with 2 drives, onde o microcode esta no level: 5466
- Fileset: Atape.driver version: 5.0.2.0
The "TSM Server Version: 5 Release: 1 Level: 0.0" - was installed in
one of the SP RS/6000. and directly connected with second drive the
3570-MP.
When we try define the label volumes, it obtains to load the first tape
of slot 41, write label obtained for barcode, unload tape. Then it loads
the second tape at 42 slot, starts to write and then it stops the
process.
if we send the command again, it unloads the second tape and obtains to
load the first tape in slot 41. It repeats the process of writing in
the first tape, then loads the second tape and constraint again
Configuration of paths for "Library Path" and "Driver Path":
-Parameter " Device Library"
1 - Library Path
Device = /dev/rmt0.smc
- Parameter "Driver.Path"
2 - Drive Path
Device = /dev/rmt0
As documentation found in the following site:
http://www.lrz-muenchen.de/services/date
nhaltung/adsm/link/tsm-v41-books/guide/anragd56.htm#HDRDDRIBMD
How do configure the 3570-MP Magstar with TSM Server 5.1.0 for AIX, to
be in full functioning??
configuration:
-SP RS/6000 System
-MAGSTAR 3570-MP with 2 drives, onde o microcode esta no level: 5466
- Fileset: Atape.driver version: 5.0.2.0
The "TSM Server Version: 5 Release: 1 Level: 0.0" - was installed in
one of the SP RS/6000. and directly connected with second drive the
3570-MP.
When we try define the label volumes, it obtains to load the first tape
of slot 41, write label obtained for barcode, unload tape. Then it loads
the second tape at 42 slot, starts to write and then it stops the
process.
if we send the command again, it unloads the second tape and obtains to
load the first tape in slot 41. It repeats the process of writing in
the first tape, then loads the second tape and constraint again
Configuration of paths for "Library Path" and "Driver Path":
-Parameter " Device Library"
1 - Library Path
Device = /dev/rmt0.smc
- Parameter "Driver.Path"
2 - Drive Path
Device = /dev/rmt0
As documentation found in the following site:
http://www.lrz-muenchen.de/services/date
nhaltung/adsm/link/tsm-v41-books/guide/anragd56.htm#HDRDDRIBMD
How do configure the 3570-MP Magstar with TSM Server 5.1.0 for AIX, to
be in full functioning??