Anyone install 6.3.6.00 server (mine is Linux) and experience any issues, in particular with expiration?
I upgraded one server on Tuesday, from 6.3.5.100 due to issues with replication that are address in 6.3.6.000. Wednesday evening I started getting alerts about the active log >80%. At this point, expiration had been running for 30+ hours (it normally finishes in an hour or so).
Fortunately, a DB backup cleared most of the log but expiration refuses to stop. Tried both 'cancel expiration' and 'cancel proc'. It acknowledged the cancel but wouldn't die.
This morning I was alerted the log >80 percent and a DB backup wouldn't clear things and the expiration was still hung. I had to bounce the server.
Expiration kicked off after I bounced the server today and is still running saying it has only processed 2-nodes after 4+ hours. I hesitate attempting to cancel it until further diagnostics can be performed.
I was going to upgrade all my servers to 6.3.6.000 but am holding off due to this situation.
Any thoughts/suggestions?
I upgraded one server on Tuesday, from 6.3.5.100 due to issues with replication that are address in 6.3.6.000. Wednesday evening I started getting alerts about the active log >80%. At this point, expiration had been running for 30+ hours (it normally finishes in an hour or so).
Fortunately, a DB backup cleared most of the log but expiration refuses to stop. Tried both 'cancel expiration' and 'cancel proc'. It acknowledged the cancel but wouldn't die.
This morning I was alerted the log >80 percent and a DB backup wouldn't clear things and the expiration was still hung. I had to bounce the server.
Expiration kicked off after I bounced the server today and is still running saying it has only processed 2-nodes after 4+ hours. I hesitate attempting to cancel it until further diagnostics can be performed.
I was going to upgrade all my servers to 6.3.6.000 but am holding off due to this situation.
Any thoughts/suggestions?